Job Description

Assembler Advanced “Electrical Test Tech” (Franklin WI)

Hours

1st Shift

• Monday - Thursday 5:00 AM - 3:30 PM
• Overtime 2 or 3 Fridays a month

Job Summary

In this job you will perform a variety of assembly and test positions for IntelliRupter and Power Quality products. You will work in a production environment, engage in continuous productive activity, and must meet requirements within time constraints. Considerable initiative required to run and process all IntilliRupter units through test and assembly cells, a fast paced multi station process.

Tasks require a high degree of eye-hand coordination, manual dexterity, and the use of both hands and arms on a repetitive basis for a full range of motion. You will frequently use hand and power tools; occasionally work while standing on ladders; and occasionally work inside tight compartments.

The responsibilities of this position include, but are not limited to, the following:

• Assemble and test IntelliRupter products based on the documentation including bills of material, blueprints and any change notices provided by the engineering staff.
• Complete testing at timing stations and run switch through 4 operations station.
• Complete mechanical work including disconnect assemblies.
• Experience troubleshooting electrical issues

You will be performing the following tests:

• Timing Test capacitor voltage 425 DC
• Partial Discharge Test AC voltage 50KV
• Dielectric test 3 phase AC voltage 60KV-70KV
• Calibration test parallel AC voltage 8.7KV-18KV in series 600 amps.
• 3 phase AC high voltage 8.7KV -18KV with 20 amps – 45 amps.
• Low voltage test capacitor voltage 425 DC

To select this job as one of interest to you, at a minimum, you must have the following:

High voltage electrical experience is required to run the required test cells. 5KV / 3phase

Demonstrate the ability to work from complex blueprints, wiring drawings, schematic diagrams, and specifications.

Demonstrate knowledge and experience to troubleshoot mechanical or electrical issues.

Demonstrate experience using and operating machining tools, hand-held tools, wiring equipment, wrenches, torque tools, and other tools.

Must follow all S&C safety standards.

Relevant Work Experience:

• Two years of experience in electrical testing & trouble shotting with 5KV2 year technical degree preferred.

1. Still need to have experience in addition to the school

• Candidates with electrical or mechanical trade school education may also be considered in lieu of experience

MAJOR PHYSICAL DEMANDS

• Standing: Most tasks are performed in a standing position with intermittent walking.
• Lifting: Frequent lifting of items ranging in weight from 5 lbs. to 40 lbs.
• Walking: Frequent walking of short distances to obtain parts for assembly.
• Carrying: Occasional carrying of items ranging in weight from 5 lbs. to 25 lbs.
• Pushing: Occasional pushing of handcart to/from assembly area containing up to 50 lbs.
• Pulling: Occasional pulling of handcart to/from assembly area containing up to 50 lbs.
• Bending: Frequent bending and crouching required to complete the assembly/wiring tasks.
• Reaching: Continuous full range of motion from above the shoulders to below the knees.
• Handling: Continuous handling of parts (all sizes) along with a variety of hand tools.

Job Tags

Similar Jobs